---

labels:

- 'Type-Auth'

...

Introduction

============

Allow client authentication to be handled by an external script/process.

Installation

============

[lpty](http://www.tset.de/lpty/). You can install it on many platforms

using [LuaRocks](http://luarocks.org/), for example:

    sudo luarocks install lpty

Configuration

=============

As with all auth modules, there is no need to add this to

modules\_enabled. Simply add in the global section, or for the relevant

hosts:

  -------------------------- -------------------------------------------------------------------------------------------------------------------------

  external\_auth\_protocol   May be "generic" or "ejabberd" (the latter for compatibility with ejabberd external auth scripts. Default is "generic".

  external\_auth\_command    The command/script to execute.

  -------------------------- -------------------------------------------------------------------------------------------------------------------------

Two other options are also available, depending on whether the module is

running in 'blocking' or 'non-blocking' mode:

  --------------------------- -------------- ------------------------------------------------------------------------------------------------------------------

  external\_auth\_timeout     blocking       The number of seconds to wait for a response from the auth process. Default is 5.

  external\_auth\_processes   non-blocking   The number of concurrent processes to spawn. Default is 1, increase to handle high connection rates efficiently.

  --------------------------- -------------- ------------------------------------------------------------------------------------------------------------------

Blocking vs non-blocking

------------------------

Non-blocking mode is experimental and is disabled by default.

Enable at your own risk if you fulfil these conditions:

-   Running Prosody trunk ([nightly](http://prosody.im/nightly/) build

    414+) or Prosody 0.11.x.

-   [libevent](http://prosody.im/doc/libevent) is enabled in the config,

    and LuaEvent is available.

-   lpty (see installation above) is version 1.0.1 or later.

```lua

external_auth_blocking = false;

```

Protocol

========

Prosody executes the given command/script, and sends it queries.

Your auth script should simply read a line from standard input, and

write the result to standard output. It must do this in a loop, until

there's nothing left to read. Prosody can keep sending more lines to the

script, with a command on each line.

Each command is one line, and the response is expected to be a single

line containing "0" for failure or "1" for success. Your script must

respond with "0" for anything it doesn't understand.

There are three commands used at the moment:

auth

----

Check if a user's password is valid.

Example: `auth:username:example.com:abc123`

Note: The password can contain colons. Make sure to handle that.

isuser

------

Check if a user exists.

Example: `isuser:username:example.com`

setpass

-------

Set a new password for the user. Implementing this is optional.

Example: `setpass:username:example.com:abc123`

Note: The password can contain colons. Make sure to handle that.

ejabberd compatibility

---------------------

ejabberd implements a similar protocol. The main difference is that

Prosody's protocol is line-based, while ejabberd's is length-prefixed.

Add this to your config if you need to use an ejabberd auth script:

        external_auth_protocol = "ejabberd"

Compatibility

=============

  ----- -------

  0.8   Works

  0.9   Works

  ----- -------