largefiles: fix commit when using relative paths from subdirectory Remove cwd handling from getstandinmatcher - it did not belong there, as proven by the tests.

largefiles: allow use of urls with #revision largefiles tried to create a peer directly with the specified url. That caused abort: unsupported URL component: "..." if a revision was specified in the url. The branch name do not matter for largefiles' use of remote peers. Largefiles will be shared among all branches anyway.

largefiles: don't verify largefile hashes on servers when processing statlfile When changesets referencing largefiles are pushed then the corresponding largefiles will be pushed too - unless the target already has them. The client will use statlfile to make sure it only sends largefiles that the target doesn't have. The server would however on every statlfile check that the content of the largefile had the expected hash. What should be cheap thus became an expensive operation that trashed the disk and the cache. Largefile hashes are already checked by putlfile before being stored on the server. A server should thus be able to keep its largefile store free of errors - even more than it can keep revlogs free of errors. Verification should happen when running 'hg verify' locally on the server. Rehashing every largefile on every remote stat is too expensive. Clients will also stat lfiles before downloading them. When the server verified the hash in stat it meant that it had to read the file twice to serve it. With this change the server will assume its own hashes are ok without checking them on every statlfile. Some consequences of this change: - in case of server side corruption the problem will be detected by the existing check on the client side - not on server side - clients that could upload an uncorrupted largefile when pushing will no longer magically heal the server (and break hardlinks) - a client will now only upload its uncorrupted files after the corrupted file has been removed on the server side - client side verify will no longer report corruption in files it doesn't have (Issue3123 discussed related problems - and how they have been fixed.)

tests: clarify test for pushing corrupted largefile The test no longer tested that the server prevented pushing a corrupt largefile. At the same time it tested what happened when the server already had a corrupt largefile. These two cases are now separated.

largefiles: verify all files in each revision and report errors in any revision Verify used 'any' and would stop verifying after the first failure in each changeset. The exit code only reported the result from the last changeset.

tests: better test coverage of largefiles localstore verify This demonstrates problems that will be fixed later.

largefiles: adapt remotestore._getfile to batched statlfile 9e1616307c4c introduced batching of statlfile, but not all codepaths got converted. _getfile gave _stat garbage and got garbage back. The garbage didn't match the expected error codes and was thus interpreted as success. It could thus end up trying to fetch a largefile that didn't exist. Instead we now pass _stat valid input and handle both correct and invalid output correctly. This makes the code work as intended ... but it would probably be better if it didn't abort on missing largefiles, just like it happened to do before.

largefiles: don't allow corruption to propagate after detection basestore.get uses util.atomictempfile when checking and receiving a new largefile ... but the close/discard logic was too clever for largefiles. Largefiles relied on being able to discard the file and thus prevent it from being written to the store. That was however too brittle. lfutil.copyandhash closes the infile after writing to it ... with a 'blecch' comment. The discard was thus a silent noop, and as a result of that corruption would be detected ... and then the corrupted files would be used anyway. Instead we now use a tmp file and rename or unlink it after validating it. A better solution should be implemented ... but not now.

largefiles: adapt verify to batched remote statlfile (issue3780) 9e1616307c4c introduced batching of statlfile, but not all codepaths got converted. 'hg verify' with a remotestore could thus crash with TypeError: 'builtin_function_or_method' object is not iterable Also, the 'hash' variable was used without assigning to it. Don't use variable names that collide with Python built-in functions. Instead we use 'expecthash' as in localstore. The tests for this issue covers an untested area. The tests happens to also reveal incorrect attempts at getting non-existing largefiles, bad server side handling of that, and corruption issues - all to be fixed later.

largefiles: let wirestore._stat return stats as expected by remotestore verify - preparing for fixing verify crash.