--- a/mcabber/doc/mcabber.1.txt Fri Apr 14 23:30:24 2006 +0200
+++ b/mcabber/doc/mcabber.1.txt Fri Apr 14 23:37:26 2006 +0200
@@ -1,7 +1,7 @@
MCABBER(1)
===========
Mikael BERTHE <mcabber@lilotux.net>
-v0.7.6-dev, April 2006
+v0.7.6, April 2006
NAME
----
@@ -190,6 +190,8 @@
line will be added to the multi-line message. Once the message is
finished, it can be sent to the current selected buddy with the "/msay
send" command. +
+ The 'begin' subcommand enables multi-line mode. Note that it allows
+ a message subject to be specified. +
The 'verbatim' multi-line mode disables commands, so that it is
possible to enter lines starting with a slash. Only the "/msay"
command (with send or abort parameters) can be used to exit verbatim
@@ -198,12 +200,12 @@
mode quickly (for example, "bind M13 = msay toggle" to switch using
the Meta-Enter combination).
- 'begin';; enter multi-line mode
- 'verbatim';; enter verbatim multi-line mode
- 'send';; send the current multi-line message to the currently selected buddy
- 'send_to' jid;; send the current multi-line message to "jid"
- 'toggle';; switch to/from multi-line mode (begin/send)
- 'abort';; leave multi-line mode without sending the message
+ 'begin' [subject];; enter multi-line mode
+ 'verbatim';; enter verbatim multi-line mode
+ 'send';; send the current multi-line message to the currently selected buddy
+ 'send_to' jid;; send the current multi-line message to "jid"
+ 'toggle';; switch to/from multi-line mode (begin/send)
+ 'abort';; leave multi-line mode without sending the message
/quit::
Disconnect and leave `mcabber(1)`.